Rob Bodington wrote up the following after sucessfully writing to the “stepmod” CVS repository:
At last .... SUCCESS.
It was a real gotcha.
I initially checked out the module without using SSH. I then set up SSH. When I then tried to check stuff back, my local copy had the initial CVSROOT - not the one needed for SSH. Hence I could not check stuff back in.
I found out where I was going wrong from https://sourceforge.net/docman/display_doc.php?docid=769&group_id=1.
Here are some additional notes on how to get CVS working with SourceForge. I distilled this from a load of help pages that Josh pointed me to. If I have anything wrong or it does not work, then let us know.
This details the software I am using - there are other ways of doing this.
This help was based on Josh's help page at http://ats.nist.gov/stepmod/cvswin.html.
Register on SourceForge, and request developer access from the stepmod project administrator. Install WinCVS - Can be down loaded from: http://www.wincvs.org/ Install the SSH software PuTTY - You need putty.exe, plink.exe, pageant.exe, puttygen.exe. The putty help pages would be a useful download as well. These can be down loaded from http://www.chiark.greenend.org.uk/~sgtatham/putty/. Useful help pages: http://sourceforge.net/docman/display_doc.php?docid=6841&group_id=1 Set up and test your SSH to connect to SourceForge. First generate and post your SSH key to SourceForge. Details on how to do this are at http://sourceforge.net/docman/display_doc.php?docid=761&group_id=1. Note - you will have to wait 6 hours before your key has been circulated. Create and save a putty session that logs on to SourceForge using SSH. On the session window:Host Name: cvs.stepmod.sourceforge.net SSH selected On the SSH window:
SSH 1 selected Specify your authentication key. Set up PLINK and CVS environment variables
set CVS_RSH=\path\to\plink.exe
set PLINK_PROTOCOL=ssh
Run pageant adding your key
Configure WinCVS
Admin->Preferences->General
CVSROOT box
:ext:putty_session_name:/cvsroot/stepmod
where putty_session_name is the name of the putty session you just created.
Admin->Preferences->Ports
Alternative rsh name
E:\apps\putty\plink.exe
Check out the repository - use the Admin->Command line
cvs -d:ext:[email protected]:/cvsroot/stepmod co stepmod
Created by Josh Lubell
Last modified Monday July 01, 2002
本文地址：http://com.8s8s.com/it/it23179.htm